Advent LCD4WM Manuel d'utilisateur télécharger pdf (Page 6)

Wiring the Camera to the Vehicle’s Reverse Lamp

1. Locate the reverse lamp in the tail light assembly.

2. Using the tap connector supplied, perform the following steps:

a) Place the un-stripped positive lead from the tail lamp in the run

channel, which runs completely through the connector.

b) Insert the un-stripped red power wire from the camera

completely into the other channel in the connector.

c) Make the connection between the wires by crimping down the

metal connector with a pair of pliers, making sure the metal is

flush with the plastic insulator.

d) Close the top plastic hinged cover until latched.

3. Attach the black wire to the ground (negative).

4. Repeat the above steps for the red wire.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Advent LCD4WM Manuel d'utilisateur Page 6