Installation GuideADV10A10.1 OVERHEAD LCD MONITORWITH DVD PLAYER"
1) Make the connections to the vehicle for the 10 pin wiring harness.2) Connect 2 Pin Power Harness to vehicle’s electrical system by tapping into an
CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of do
© 2011 ADVENT, 150 Marcus Blvd. Hauppauge, NY 11788128-8934Red / black - Lamp onTo 3 pinconnectorToconstant+12 VDCToconstant+12 VDCBlack / red - Lamp
Important NoticeAn LCD panel and/or video monitor may be installed in a motor vehicle and visible to thedriver if the LCD panel or video monitor is us
MATERIALS INCLUDED IN THIS PACKAGE:1) 10.1” TFT LCD Overhead Monitor With DVD Player - (1 pc)2) Hardware Package (P/N 150-1661) - (1 pc)- M3 x 8mm Phi
catch catchBegin by hooking area “A” (above) over the dome light and slide the cover over the unit. The cover will snap in place.Place the unit on a s
2 35Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press the p
VEHICLE PREPARATION:1) Locate an accessory power source (+12v when the key is in the ACC. and run positions, and 0vwhen the key is off), and also a go
7GENERAL SYSTEM CONFIGURATIONS:The following is intended to provide some of the system configurations that are possible with theADV10A Drop Down Video
TRIM RING INSTALLATION:Note:Note:This page only covers special installation considerations for thick trim ring installation. If the videomonitor is to
TRIM RING INSTALLATION:To install the Trim Ring to the unit, use the supplied screws listed below:A) #4 x 5/16 Phillips Self Tapping Screws (1 pc)B) #
Commentaires sur ces manuels